|
Thanks, both of you. And looking very closely, I see that th... Nel forum Hardware, firmware and software help |
4 years fa |
|
"z leveling enforced" Nel forum Hardware, firmware and software help |
4 years fa |
|
Cold Pull Gone Wrong Nel forum Hardware, firmware and software help |
5 years fa |
|
Thank you for the advice - that was very helpful on a fundam... Nel forum Hardware, firmware and software help |
6 years fa |
|
Mesh Bed Leveling Fail Nel forum Hardware, firmware and software help |
6 years fa |
|
Oops - I see that I've posted this in the MK3 forum instead ... Nel forum Hardware, firmware and software help |
6 years fa |
|
Z Calibration Fail Nel forum Hardware, firmware and software help |
6 years fa |
|
But wouldn't whatever pulled he extruder out of whack have b... Nel forum Others (Archive) |
8 years fa |
|
That looks like the same problem, but maybe a different caus... Nel forum Others (Archive) |
8 years fa |
|
Thanks for the advice. Belts look good, and the bundle of ca... Nel forum Others (Archive) |
8 years fa |
|
Uh oh - not so fast. After switching to the Prusa edition of... Nel forum Others (Archive) |
8 years fa |
|
Thanks, everyone. It was the filament diameter setting in Cu... Nel forum Others (Archive) |
8 years fa |
|
I bought this printer assembled, so chances are that it's no... Nel forum Others (Archive) |
8 years fa |
|
Layer Offset Fail Nel forum Others (Archive) |
8 years fa |
