Prusa3D Forum

Notifications

Clear all

duckpodger

Grupa: Zarejestrowany

Dołączył: 2023/08/01

Active Member

	Using this test piece/p> I dialed it in even better and go... In forum Hardware, firmware and software help	1 year temu
	Forgot to say that the print was 3.00mm wide at the brim all... In forum Hardware, firmware and software help	1 year temu
	Thanks for all the help. I re-ran the first layer calibratio... In forum Hardware, firmware and software help	1 year temu
	Many thanks for your feedback, it makes a lot of sense (espe... In forum Hardware, firmware and software help	1 year temu
	Thank you very much for a speedy reply! The first print of t... In forum Hardware, firmware and software help	1 year temu
	What would cause this scuffing when printing? In forum Hardware, firmware and software help	1 year temu

Statystyki Forum

565 Fora

63.6 K Tematy

446.1 K Posty

21 Online

68.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte