Prusa3D Forum

Notifications

Clear all

duckpodger

Group: Registered

Joined: 2023/08/01

Active Member

	Using this test piece/p> I dialed it in even better and go... In forum Hardware, firmware and software help	1 year ago
	Forgot to say that the print was 3.00mm wide at the brim all... In forum Hardware, firmware and software help	1 year ago
	Thanks for all the help. I re-ran the first layer calibratio... In forum Hardware, firmware and software help	1 year ago
	Many thanks for your feedback, it makes a lot of sense (espe... In forum Hardware, firmware and software help	1 year ago
	Thank you very much for a speedy reply! The first print of t... In forum Hardware, firmware and software help	1 year ago
	What would cause this scuffing when printing? In forum Hardware, firmware and software help	1 year ago

Forum Statistics

565 Forums

63.6 K Topics

446.1 K Posts

20 Online

68.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed