Avisos
Vaciar todo
duckpodger
Grupo: Registrado
Registrado: 2023/08/01
Active Member
1
|
Using this test piece/p>
I dialed it in even better and go... En el foro Hardware, firmware and software help |
hace 2 years | |
|
Forgot to say that the print was 3.00mm wide at the brim all... En el foro Hardware, firmware and software help |
hace 2 years | |
|
Thanks for all the help. I re-ran the first layer calibratio... En el foro Hardware, firmware and software help |
hace 2 years | |
|
Many thanks for your feedback, it makes a lot of sense (espe... En el foro Hardware, firmware and software help |
hace 2 years | |
|
Thank you very much for a speedy reply! The first print of t... En el foro Hardware, firmware and software help |
hace 2 years | |
|
What would cause this scuffing when printing? En el foro Hardware, firmware and software help |
hace 2 years |