Prusa3D Forum

Notifiche

Cancella tutti

duckpodger

Gruppo: Registrato

Registrato: 2023/08/01

Active Member

	Using this test piece/p> I dialed it in even better and go... Nel forum Hardware, firmware and software help	1 year fa
	Forgot to say that the print was 3.00mm wide at the brim all... Nel forum Hardware, firmware and software help	1 year fa
	Thanks for all the help. I re-ran the first layer calibratio... Nel forum Hardware, firmware and software help	1 year fa
	Many thanks for your feedback, it makes a lot of sense (espe... Nel forum Hardware, firmware and software help	1 year fa
	Thank you very much for a speedy reply! The first print of t... Nel forum Hardware, firmware and software help	1 year fa
	What would cause this scuffing when printing? Nel forum Hardware, firmware and software help	1 year fa

Statistiche Forum

565 Forum

63.6 K Discussioni

446.1 K Post

22 Online

68.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso