|
PS 2.8.1 - my Prusa Mk3.9 is very slow after latest firmware... In forum PrusaSlicer |
7 months ago |
|
Thanks for explaining Neophyl 👍 In forum PrusaSlicer |
11 months ago |
|
PrusaSlicer 2.8.0 - Thumbnail is not sliced part In forum PrusaSlicer |
11 months ago |
|
Yes, belt tension and moving the pulleys closer to the motor... In forum Assembly and first prints troubleshooting |
12 months ago |
|
That's basically what I print with.Steel sheet is cleaned wi... In forum Hardware, firmware and software help |
1 year ago |
|
I guess I'm not the only one then.Just finished my Mk3.9 upg... In forum Hardware, firmware and software help |
1 year ago |
|
I have just spent over 4 hours with 2 people on LiveChat and... In forum Assembly and first prints troubleshooting |
1 year ago |
|
Hi Joan, Lol, no. But I slacked off the bearing holders a bi... In forum Assembly and first prints troubleshooting |
1 year ago |
|
Hi Joan Regarding the X axis all ties are correct and do not... In forum Assembly and first prints troubleshooting |
1 year ago |
|
Hi Joan, Thank you for answering my question, I wasn't sure ... In forum Assembly and first prints troubleshooting |
1 year ago |
|
Zounds, thank you for the suggestion. I have checked the Z a... In forum Assembly and first prints troubleshooting |
1 year ago |
|
MK3.9 - Z axis calibration fails In forum Assembly and first prints troubleshooting |
1 year ago |
|
Hi, So I have just finished the 3.9 upgrade and have the dre... In forum Assembly and first prints troubleshooting |
1 year ago |
|
Hi Joan, thanks for the reply. Yes I've moved that to the ST... In forum PrusaSlicer |
3 years ago |
|
PrusaSlicer adding gcode to output file In forum PrusaSlicer |
3 years ago |
