Notifications
Clear all
Doddster55
Doddster55
Skupina: Registrovaný
Přidal se: 2022/11/09
Active Member
1
PS 2.8.1 - my Prusa Mk3.9 is very slow after latest firmware...

In forum PrusaSlicer

před 4 months
Thanks for explaining Neophyl 👍

In forum PrusaSlicer

před 8 months
PrusaSlicer 2.8.0 - Thumbnail is not sliced part

In forum PrusaSlicer

před 8 months
Yes, belt tension and moving the pulleys closer to the motor...

In forum Assembly and first prints troubleshooting

před 10 months
That's basically what I print with.Steel sheet is cleaned wi...

In forum Hardware, firmware and software help

před 1 year
I guess I'm not the only one then.Just finished my Mk3.9 upg...

In forum Hardware, firmware and software help

před 1 year
I have just spent over 4 hours with 2 people on LiveChat and...

In forum Assembly and first prints troubleshooting

před 1 year
Hi Joan, Lol, no. But I slacked off the bearing holders a bi...

In forum Assembly and first prints troubleshooting

před 1 year
Hi Joan Regarding the X axis all ties are correct and do not...

In forum Assembly and first prints troubleshooting

před 1 year
Hi Joan, Thank you for answering my question, I wasn't sure ...

In forum Assembly and first prints troubleshooting

před 1 year
Zounds, thank you for the suggestion. I have checked the Z a...

In forum Assembly and first prints troubleshooting

před 1 year
MK3.9 - Z axis calibration fails

In forum Assembly and first prints troubleshooting

před 1 year
Hi, So I have just finished the 3.9 upgrade and have the dre...

In forum Assembly and first prints troubleshooting

před 1 year
Hi Joan, thanks for the reply. Yes I've moved that to the ST...

In forum PrusaSlicer

před 2 years
PrusaSlicer adding gcode to output file

In forum PrusaSlicer

před 2 years
Share: