|
Thanks for explaining Neophyl 👍 Im Forum PrusaSlicer |
Vor 7 days |
|
PrusaSlicer 2.8.0 - Thumbnail is not sliced part Im Forum PrusaSlicer |
Vor 7 days |
|
Yes, belt tension and moving the pulleys closer to the motor... Im Forum Assembly and first prints troubleshooting |
Vor 2 months |
|
That's basically what I print with.Steel sheet is cleaned wi... Im Forum Hardware, firmware and software help |
Vor 4 months |
|
I guess I'm not the only one then.Just finished my Mk3.9 upg... Im Forum Hardware, firmware and software help |
Vor 4 months |
|
I have just spent over 4 hours with 2 people on LiveChat and... Im Forum Assembly and first prints troubleshooting |
Vor 5 months |
|
Hi Joan, Lol, no. But I slacked off the bearing holders a bi... Im Forum Assembly and first prints troubleshooting |
Vor 5 months |
|
Hi Joan Regarding the X axis all ties are correct and do not... Im Forum Assembly and first prints troubleshooting |
Vor 5 months |
|
Hi Joan, Thank you for answering my question, I wasn't sure ... Im Forum Assembly and first prints troubleshooting |
Vor 5 months |
|
Zounds, thank you for the suggestion. I have checked the Z a... Im Forum Assembly and first prints troubleshooting |
Vor 5 months |
|
MK3.9 - Z axis calibration fails Im Forum Assembly and first prints troubleshooting |
Vor 5 months |
|
Hi, So I have just finished the 3.9 upgrade and have the dre... Im Forum Assembly and first prints troubleshooting |
Vor 5 months |
|
Hi Joan, thanks for the reply. Yes I've moved that to the ST... Im Forum PrusaSlicer |
Vor 2 years |
|
PrusaSlicer adding gcode to output file Im Forum PrusaSlicer |
Vor 2 years |
