Notifications
Clear all
Doc
Skupina: Registrovaný
Přidal se: 2016/11/25
Active Member
1
| These pictures and this code were a Godsend! Thank you very... | před 8 years | |
| The end of the story -- As it turns out, the PINDA was fine... | před 8 years | |
| Suggestions on how to proceed? | před 8 years | |
| Interesting. I can get the PINDA probe to flash by putting ... | před 8 years | |
| Thanks for that idea, but that is not something I have layin... | před 8 years | |
| Ferrous metal attached to the bed did nothing to change the ... | před 8 years | |
| "this should allow a correct detection of the printbed inlay... | před 8 years | |
| Anyone with additional ideas? | před 8 years | |
| The base of mine is illuminated where it connects to the cab... | před 8 years | |
| I understand that, however, the PINDA cannot go any lower wi... | před 8 years | |
| Thank you. I have verified that the Y axis is completely do... | před 8 years | |
| I forgot to mention - yes the bed is heated. | před 8 years | |
| Print nozzle hitting bed with PINDA all the way down. | před 8 years |