Prusa3D Forum

Notifications

Clear all

Dieter

Grupa: Zarejestrowany

Dołączył: 2018/09/29

Active Member

	@neophyl I opened it in the Firmware repository, as the prin... In forum Hardware, firmware and software help	4 years temu
	Even the printer restarted always at the same position (so I... In forum Hardware, firmware and software help	4 years temu
	I replaced the thermistor, after this everything was ok In forum Hardware, firmware and software help	4 years temu
	Slicer-2.2.0-P30_Wheel_Default_0.15mm_PLA_MK3S_6h39m.gcode S... In forum Hardware, firmware and software help	4 years temu
	Printer restarts during printing when using PrusaSlicer 2.2.... In forum Hardware, firmware and software help	4 years temu
	Jumping hot end temperature during printing In forum Hardware, firmware and software help	5 years temu

Statystyki Forum

566 Fora

63.2 K Tematy

444.2 K Posty

20 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte