Prusa3D Forum

Notifiche

Cancella tutti

Dieter

Gruppo: Registrato

Registrato: 2018/09/29

Active Member

	@neophyl I opened it in the Firmware repository, as the prin... Nel forum Hardware, firmware and software help	5 years fa
	Even the printer restarted always at the same position (so I... Nel forum Hardware, firmware and software help	5 years fa
	I replaced the thermistor, after this everything was ok Nel forum Hardware, firmware and software help	5 years fa
	Slicer-2.2.0-P30_Wheel_Default_0.15mm_PLA_MK3S_6h39m.gcode S... Nel forum Hardware, firmware and software help	5 years fa
	Printer restarts during printing when using PrusaSlicer 2.2.... Nel forum Hardware, firmware and software help	5 years fa
	Jumping hot end temperature during printing Nel forum Hardware, firmware and software help	5 years fa

Statistiche Forum

585 Forum

67.9 K Discussioni

476.2 K Post

11 Online

75.6 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso