Avisos
Vaciar todo
Dieter
Grupo: Registrado
Registrado: 2018/09/29
Active Member
1
|
@neophyl I opened it in the Firmware repository, as the prin... En el foro Hardware, firmware and software help |
hace 4 years | |
|
Even the printer restarted always at the same position (so I... En el foro Hardware, firmware and software help |
hace 4 years | |
|
I replaced the thermistor, after this everything was ok En el foro Hardware, firmware and software help |
hace 4 years | |
|
Slicer-2.2.0-P30_Wheel_Default_0.15mm_PLA_MK3S_6h39m.gcode S... En el foro Hardware, firmware and software help |
hace 4 years | |
|
Printer restarts during printing when using PrusaSlicer 2.2.... En el foro Hardware, firmware and software help |
hace 4 years | |
|
Jumping hot end temperature during printing En el foro Hardware, firmware and software help |
hace 5 years |