Prusa3D Forum

Notifications

Clear all

Dieter

Skupina: Registrovaný

Přidal se: 2018/09/29

Active Member

	@neophyl I opened it in the Firmware repository, as the prin... In forum Hardware, firmware and software help	před 5 years
	Even the printer restarted always at the same position (so I... In forum Hardware, firmware and software help	před 5 years
	I replaced the thermistor, after this everything was ok In forum Hardware, firmware and software help	před 5 years
	Slicer-2.2.0-P30_Wheel_Default_0.15mm_PLA_MK3S_6h39m.gcode S... In forum Hardware, firmware and software help	před 5 years
	Printer restarts during printing when using PrusaSlicer 2.2.... In forum Hardware, firmware and software help	před 5 years
	Jumping hot end temperature during printing In forum Hardware, firmware and software help	před 5 years

Fórum Statistiky

585 Fóra

67.9 K Témata

476.2 K Příspěvky

14 Online

75.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed