|
Thanks, it works great with the Prusa PLA settings (which do... In forum General discussion, announcements and releases |
4 years ago |
|
Overture PLA Professional settings? In forum General discussion, announcements and releases |
4 years ago |
|
What does "filaments marked with a * are NOT compatible with... In forum General discussion, announcements and releases |
4 years ago |
|
The "issue" is that I don't want to have 16 profiles. Althou... In forum PrusaSlicer |
5 years ago |
|
Ran into a bit of an issue though: Apparently, one must chan... In forum PrusaSlicer |
5 years ago |
|
Thanks! The only bit missing from your answer is that one mu... In forum PrusaSlicer |
5 years ago |
|
Can I remove the "MK3S" from the saved filename's template? In forum PrusaSlicer |
5 years ago |
|
Load filament double tap issue In forum Hardware, firmware and software help |
5 years ago |
|
@charles-h13 I love that you are a "Famed Member"! Also, I n... In forum Hardware, firmware and software help |
5 years ago |
|
Filament got stuck again In forum Hardware, firmware and software help |
5 years ago |
|
@karl-herbert Thanks! I heated it up, but it didn't come out... In forum Hardware, firmware and software help |
5 years ago |
|
This is the filament that was above the gears: This is the ... In forum Hardware, firmware and software help |
5 years ago |
|
Printer chewed up filament at the bowden gears again. In forum Hardware, firmware and software help |
5 years ago |
|
@stefan-b20 Thanks! I couldn't quite tell from the descripti... In forum Hardware, firmware and software help |
5 years ago |
|
Did it look something like this? I had a print stop, no erro... In forum Hardware, firmware and software help |
5 years ago |
|
I couldn't figure out how to attach the photos in time, so h... In forum Hardware, firmware and software help |
5 years ago |
|
@jsw Thanks for the help! I gave my bed a good cleaning, and... In forum Hardware, firmware and software help |
5 years ago |
|
@bobstro This answer was amazingly helpful! The official ins... In forum Hardware, firmware and software help |
5 years ago |
|
Printer no longer extrudes correctly In forum Hardware, firmware and software help |
5 years ago |
|
Thanks for this! I saw "EVERYTHING ABOUT NOZZLES WITH A DIFF... In forum Hardware, firmware and software help |
7 years ago |
