Prusa3D Forum

Notifications

Clear all

David Chilson

Grupa: Zarejestrowany

Dołączył: 2023/04/15

Active Member

	I can check the profile and see. I don’t believe my experien... In forum How do I print this? (Printing help)	2 years temu
	I used a machinists dial indicator after assembly and my bed... In forum How do I print this? (Printing help)	2 years temu
	I've spent about 10 hours so far today and 12 hours yesterda... In forum How do I print this? (Printing help)	2 years temu
	I was using 3x3, I wasn't aware it could be changed in the o... In forum How do I print this? (Printing help)	2 years temu
	I followed the steps in the link you provided and it seemed ... In forum How do I print this? (Printing help)	2 years temu
	I use the inbuilt first layer calibration, but it doesn't ev... In forum How do I print this? (Printing help)	2 years temu
	I typically have it approximately 100mm from the print bed b... In forum How do I print this? (Printing help)	2 years temu
	I apologize for the late responses, I've been travelling for... In forum How do I print this? (Printing help)	2 years temu
	I have tried both sides of this sheet and even changed to a ... In forum How do I print this? (Printing help)	2 years temu
	As an update. My 28th print attempt was finally successful f... In forum How do I print this? (Printing help)	2 years temu
	PETG Issues In forum How do I print this? (Printing help)	2 years temu

Statystyki Forum

566 Fora

63.2 K Tematy

444.3 K Posty

19 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte