Prusa3D Forum

Notifications

Clear all

David Chilson

Groupe: Enregistré

A(ont) rejoint: 2023/04/15

Active Member

	I can check the profile and see. I don’t believe my experien... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I used a machinists dial indicator after assembly and my bed... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I've spent about 10 hours so far today and 12 hours yesterda... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I was using 3x3, I wasn't aware it could be changed in the o... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I followed the steps in the link you provided and it seemed ... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I use the inbuilt first layer calibration, but it doesn't ev... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I typically have it approximately 100mm from the print bed b... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I apologize for the late responses, I've been travelling for... Dans le forum How do I print this? (Printing help)	il y a 2 years
	I have tried both sides of this sheet and even changed to a ... Dans le forum How do I print this? (Printing help)	il y a 2 years
	As an update. My 28th print attempt was finally successful f... Dans le forum How do I print this? (Printing help)	il y a 2 years
	PETG Issues Dans le forum How do I print this? (Printing help)	il y a 2 years

Statistiques du forum

566 Forums

63.2 K Sujets

444.3 K Messages

19 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé