Prusa3D Forum

Notifiche

Cancella tutti

David Chilson

Gruppo: Registrato

Registrato: 2023/04/15

Active Member

	I can check the profile and see. I don’t believe my experien... Nel forum How do I print this? (Printing help)	2 years fa
	I used a machinists dial indicator after assembly and my bed... Nel forum How do I print this? (Printing help)	2 years fa
	I've spent about 10 hours so far today and 12 hours yesterda... Nel forum How do I print this? (Printing help)	2 years fa
	I was using 3x3, I wasn't aware it could be changed in the o... Nel forum How do I print this? (Printing help)	2 years fa
	I followed the steps in the link you provided and it seemed ... Nel forum How do I print this? (Printing help)	2 years fa
	I use the inbuilt first layer calibration, but it doesn't ev... Nel forum How do I print this? (Printing help)	2 years fa
	I typically have it approximately 100mm from the print bed b... Nel forum How do I print this? (Printing help)	2 years fa
	I apologize for the late responses, I've been travelling for... Nel forum How do I print this? (Printing help)	2 years fa
	I have tried both sides of this sheet and even changed to a ... Nel forum How do I print this? (Printing help)	2 years fa
	As an update. My 28th print attempt was finally successful f... Nel forum How do I print this? (Printing help)	2 years fa
	PETG Issues Nel forum How do I print this? (Printing help)	2 years fa

Statistiche Forum

559 Forum

62.8 K Discussioni

442.5 K Post

18 Online

67.4 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso