Prusa3D Forum

Benachrichtigungen

Alles löschen

David Chilson

Gruppe: Registriert

Beigetreten: 2023/04/15

Active Member

	I can check the profile and see. I don’t believe my experien... Im Forum How do I print this? (Printing help)	Vor 2 years
	I used a machinists dial indicator after assembly and my bed... Im Forum How do I print this? (Printing help)	Vor 2 years
	I've spent about 10 hours so far today and 12 hours yesterda... Im Forum How do I print this? (Printing help)	Vor 2 years
	I was using 3x3, I wasn't aware it could be changed in the o... Im Forum How do I print this? (Printing help)	Vor 2 years
	I followed the steps in the link you provided and it seemed ... Im Forum How do I print this? (Printing help)	Vor 2 years
	I use the inbuilt first layer calibration, but it doesn't ev... Im Forum How do I print this? (Printing help)	Vor 2 years
	I typically have it approximately 100mm from the print bed b... Im Forum How do I print this? (Printing help)	Vor 2 years
	I apologize for the late responses, I've been travelling for... Im Forum How do I print this? (Printing help)	Vor 2 years
	I have tried both sides of this sheet and even changed to a ... Im Forum How do I print this? (Printing help)	Vor 2 years
	As an update. My 28th print attempt was finally successful f... Im Forum How do I print this? (Printing help)	Vor 2 years
	PETG Issues Im Forum How do I print this? (Printing help)	Vor 2 years

Forums-Statistiken

566 Foren

63.2 K Themen

444.2 K Beiträge

20 Online

68.1 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen