Čeština
Fóra
Uživatelé
Danlad1631
Aktivita
 
Notifications
Clear all
Danlad1631
Danlad1631
Skupina: Registrovaný
Přidal se: 2016/09/06
Eminent Member
2
Profile Aktivita
pjr, would you share your kiss settings? I used kiss when I ...

In forum Others (Archive)

 před 7 years
Ok, what temps are you using? Thanks

In forum Others (Archive)

 před 7 years
Amazon UK filaments

In forum Others (Archive)

 před 7 years
Lol

In forum General discussion, announcements and releases

 před 7 years
Does it need to be printed with support? The attached image ...

In forum General discussion, announcements and releases

 před 7 years
If it's a small part I would print 2 or 3 of the same item, ...

In forum Others (Archive)

 před 7 years
Hi, I increased the temp to 110 and had to add a brim, tha...

In forum Others (Archive)

 před 7 years
Flexifil TPC keeps lifting in corners

In forum Others (Archive)

 před 7 years
Sorry for the delayed response. The print is leaning back. ...

In forum Others (Archive)

 před 7 years
Print way off vertical?

In forum Others (Archive)

 před 7 years
Since I bought the printer about 10 months ago I haven't bou...

In forum Others (Archive)

 před 7 years
Postage is to expensive.

In forum Others (Archive)

 před 7 years
Bed level issue

In forum Others (Archive)

 před 7 years
Cannot print lamp base

In forum Others (Archive)

 před 7 years
Mines the same, I think it's where the hotend cartridge is p...

In forum Others (Archive)

 před 7 years
I'm printing with PLA but no enclosure, PLA is made by prima...

In forum Others (Archive)

 před 7 years
Ripples on top surface?

In forum Others (Archive)

 před 7 years
I've been adding it to my start code and works ok for me.

In forum Others (Archive)

 před 7 years
What to do with my old printer??

In forum Others (Archive)

 před 7 years
Thanks for the reply. What would I type to find the current...

In forum Others (Archive)

 před 7 years
Stránka 1 / 2
Share: