Notifications
Clear all
Danlad1631
Skupina: Registrovaný
Přidal se: 2016/09/06
Eminent Member
2
|
Extruder calibration? In forum Others (Archive) |
před 9 years | |
| Sorry Patrick didn't see your previous post. I had to calibr... | před 9 years | |
| Ok, I had a mendel90 before this and it never had this issue... | před 9 years | |
| Thanks for the reply. Attached are the results, all images ... | před 9 years | |
| Any adive on these issues? I'm still getting the gaps on s... | před 9 years | |
|
Good point, I'll have a look tomorrow at work and report bac... In forum Print tips (Archive) |
před 9 years | |
|
Bad corners? In forum Print tips (Archive) |
před 9 years | |
| Few issues. Can you help? | před 9 years |
Stránka 2 / 2
Předchozí