Prusa3D Forum

Notifiche

Cancella tutti

DaddyFixIt

Gruppo: Registrato

Registrato: 2018/10/07

Active Member

	I think I have the same problem. When cleaning the gooped-up... Nel forum Hardware, firmware and software help	1 year fa
	Thanks Joan; I was afraid you were going to say that. I had... Nel forum How do I print this? (Printing help)	5 years fa
	Can I use a 2.85 filament in the Prusa i3 MK3, as is? Nel forum How do I print this? (Printing help)	5 years fa
	Sounds like my UPSU will have an additional improvement side... Nel forum Hardware, firmware and software help	6 years fa
	UPSU for Prusa Nel forum Hardware, firmware and software help	6 years fa
	I usually use soap and hot water to clean it for that reason... Nel forum How do I print this? (Printing help)	6 years fa
	I've gone over the z calibration over and over. Im at the po... Nel forum How do I print this? (Printing help)	6 years fa

Statistiche Forum

585 Forum

67.9 K Discussioni

476.1 K Post

15 Online

75.5 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso