Notifications
Clear all
DaddyFixIt
Skupina: Registrovaný
Přidal se: 2018/10/07
Active Member
1
|
I think I have the same problem. When cleaning the gooped-up... In forum Hardware, firmware and software help |
před 6 months | |
|
Thanks Joan; I was afraid you were going to say that. I had... In forum How do I print this? (Printing help) |
před 4 years | |
|
Can I use a 2.85 filament in the Prusa i3 MK3, as is? In forum How do I print this? (Printing help) |
před 4 years | |
|
Sounds like my UPSU will have an additional improvement side... In forum Hardware, firmware and software help |
před 5 years | |
|
UPSU for Prusa In forum Hardware, firmware and software help |
před 5 years | |
|
I usually use soap and hot water to clean it for that reason... In forum How do I print this? (Printing help) |
před 5 years | |
|
I've gone over the z calibration over and over. Im at the po... In forum How do I print this? (Printing help) |
před 5 years |