Notifications
Clear all
DaddyFixIt
Groupe: Enregistré
A(ont) rejoint: 2018/10/07
Active Member
1
|
I think I have the same problem. When cleaning the gooped-up... Dans le forum Hardware, firmware and software help |
il y a 6 months | |
|
Thanks Joan; I was afraid you were going to say that. I had... Dans le forum How do I print this? (Printing help) |
il y a 4 years | |
|
Can I use a 2.85 filament in the Prusa i3 MK3, as is? Dans le forum How do I print this? (Printing help) |
il y a 4 years | |
|
Sounds like my UPSU will have an additional improvement side... Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
UPSU for Prusa Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
I usually use soap and hot water to clean it for that reason... Dans le forum How do I print this? (Printing help) |
il y a 5 years | |
|
I've gone over the z calibration over and over. Im at the po... Dans le forum How do I print this? (Printing help) |
il y a 5 years |