Prusa3D Forum

Notifications

Clear all

DaddyFixIt

Group: Registered

Joined: 2018/10/07

Active Member

	I think I have the same problem. When cleaning the gooped-up... In forum Hardware, firmware and software help	1 year ago
	Thanks Joan; I was afraid you were going to say that. I had... In forum How do I print this? (Printing help)	5 years ago
	Can I use a 2.85 filament in the Prusa i3 MK3, as is? In forum How do I print this? (Printing help)	5 years ago
	Sounds like my UPSU will have an additional improvement side... In forum Hardware, firmware and software help	6 years ago
	UPSU for Prusa In forum Hardware, firmware and software help	6 years ago
	I usually use soap and hot water to clean it for that reason... In forum How do I print this? (Printing help)	6 years ago
	I've gone over the z calibration over and over. Im at the po... In forum How do I print this? (Printing help)	6 years ago

Forum Statistics

585 Forums

68.3 K Topics

478.1 K Posts

13 Online

76 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed