Prusa3D Forum

Notifications

Clear all

CupertinoGeek

Grupa: Zarejestrowany

Dołączył: 2023/08/13

Active Member

	This went off the rails and in a total different direction f... In forum Input Shaper (MK4)	1 year temu
	Yes, that oozing thread was me telling others about that fin... In forum Input Shaper (MK4)	1 year temu
	No. It is fine to use the rough side of the sponge. In forum Input Shaper (MK4)	1 year temu
	Thanks. This is not a typical adhesion issue. I am very awar... In forum Input Shaper (MK4)	1 year temu
	Thanks for the reply and the insight of what you are seeing.... In forum Input Shaper (MK4)	1 year temu
	Started happening with Input Shaping In forum Input Shaper (MK4)	1 year temu
	You bring up a point to consider. I am not having any spaghe... In forum Input Shaper (MK4)	1 year temu
	Awesome. The issues that I was seeing with 5.0 appear to hav... In forum Input Shaper (MK4)	1 year temu
	Just out of curiosity, are you seeing this with PETG or PLA?... In forum Input Shaper (MK4)	1 year temu
	Good to know. My solution was to clean the nozzle seconds be... In forum Input Shaper (MK4)	1 year temu
	It is what they said. So, I assume as well something somewha... In forum Input Shaper (MK4)	1 year temu
	Happily, I say Good bye…. In forum Input Shaper (MK4)	1 year temu
	Great news even though the RC is working pretty well for me.... In forum Input Shaper (MK4)	1 year temu
	Alpha 4 was working well for me. So Far, I see no issues wit... In forum Input Shaper (MK4)	1 year temu

Statystyki Forum

559 Fora

63 K Tematy

443.5 K Posty

23 Online

67.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte