Prusa3D Forum

Notifications

Clear all

CupertinoGeek

Skupina: Registrovaný

Přidal se: 2023/08/13

Active Member

	This went off the rails and in a total different direction f... In forum Input Shaper (MK4)	před 2 years
	Yes, that oozing thread was me telling others about that fin... In forum Input Shaper (MK4)	před 2 years
	No. It is fine to use the rough side of the sponge. In forum Input Shaper (MK4)	před 2 years
	Thanks. This is not a typical adhesion issue. I am very awar... In forum Input Shaper (MK4)	před 2 years
	Thanks for the reply and the insight of what you are seeing.... In forum Input Shaper (MK4)	před 2 years
	Started happening with Input Shaping In forum Input Shaper (MK4)	před 2 years
	You bring up a point to consider. I am not having any spaghe... In forum Input Shaper (MK4)	před 2 years
	Awesome. The issues that I was seeing with 5.0 appear to hav... In forum Input Shaper (MK4)	před 2 years
	Just out of curiosity, are you seeing this with PETG or PLA?... In forum Input Shaper (MK4)	před 2 years
	Good to know. My solution was to clean the nozzle seconds be... In forum Input Shaper (MK4)	před 2 years
	It is what they said. So, I assume as well something somewha... In forum Input Shaper (MK4)	před 2 years
	Happily, I say Good bye…. In forum Input Shaper (MK4)	před 2 years
	Great news even though the RC is working pretty well for me.... In forum Input Shaper (MK4)	před 2 years
	Alpha 4 was working well for me. So Far, I see no issues wit... In forum Input Shaper (MK4)	před 2 years

Fórum Statistiky

585 Fóra

68 K Témata

476.8 K Příspěvky

12 Online

75.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed