Prusa3D Forum

Notifications

Clear all

CupertinoGeek

Groupe: Enregistré

A(ont) rejoint: 2023/08/13

Active Member

	This went off the rails and in a total different direction f... Dans le forum Input Shaper (MK4)	il y a 1 year
	Yes, that oozing thread was me telling others about that fin... Dans le forum Input Shaper (MK4)	il y a 1 year
	No. It is fine to use the rough side of the sponge. Dans le forum Input Shaper (MK4)	il y a 1 year
	Thanks. This is not a typical adhesion issue. I am very awar... Dans le forum Input Shaper (MK4)	il y a 1 year
	Thanks for the reply and the insight of what you are seeing.... Dans le forum Input Shaper (MK4)	il y a 1 year
	Started happening with Input Shaping Dans le forum Input Shaper (MK4)	il y a 1 year
	You bring up a point to consider. I am not having any spaghe... Dans le forum Input Shaper (MK4)	il y a 1 year
	Awesome. The issues that I was seeing with 5.0 appear to hav... Dans le forum Input Shaper (MK4)	il y a 1 year
	Just out of curiosity, are you seeing this with PETG or PLA?... Dans le forum Input Shaper (MK4)	il y a 1 year
	Good to know. My solution was to clean the nozzle seconds be... Dans le forum Input Shaper (MK4)	il y a 1 year
	It is what they said. So, I assume as well something somewha... Dans le forum Input Shaper (MK4)	il y a 1 year
	Happily, I say Good bye…. Dans le forum Input Shaper (MK4)	il y a 1 year
	Great news even though the RC is working pretty well for me.... Dans le forum Input Shaper (MK4)	il y a 1 year
	Alpha 4 was working well for me. So Far, I see no issues wit... Dans le forum Input Shaper (MK4)	il y a 1 year

Statistiques du forum

559 Forums

63.1 K Sujets

443.8 K Messages

23 En-ligne

68 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé