Prusa3D Forum

Notifiche

Cancella tutti

Cramb7

Gruppo: Registrato

Registrato: 2023/01/18

Active Member

	stupid me found the problem. there was some filament stuck u... Nel forum Hardware, firmware and software help	2 years fa
	Yeah but why does this occur so suddenly? Nel forum Hardware, firmware and software help	2 years fa
	So i looked at the axle while printing. It was always rotati... Nel forum Hardware, firmware and software help	2 years fa
	Not sure if I understand axle right. You mean the middle thi... Nel forum Hardware, firmware and software help	2 years fa
	So i moved the model and did also a first layer calibration.... Nel forum Hardware, firmware and software help	2 years fa
	Hmm. In fact, after I removed the blob around the jammed noz... Nel forum Hardware, firmware and software help	2 years fa
	Yeah I could try that Anyway, a small print worked fine Bu... Nel forum Hardware, firmware and software help	2 years fa
	Doesnt extrude at certain position Nel forum Hardware, firmware and software help	2 years fa

Statistiche Forum

559 Forum

62.6 K Discussioni

441.7 K Post

20 Online

67.1 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso