Avisos
Vaciar todo
Cramb7
Grupo: Registrado
Registrado: 2023/01/18
Active Member
1
|
stupid me found the problem. there was some filament stuck u... En el foro Hardware, firmware and software help |
hace 2 years | |
|
Yeah but why does this occur so suddenly? En el foro Hardware, firmware and software help |
hace 2 years | |
|
So i looked at the axle while printing. It was always rotati... En el foro Hardware, firmware and software help |
hace 2 years | |
|
Not sure if I understand axle right. You mean the middle thi... En el foro Hardware, firmware and software help |
hace 2 years | |
|
So i moved the model and did also a first layer calibration.... En el foro Hardware, firmware and software help |
hace 2 years | |
|
Hmm. In fact, after I removed the blob around the jammed noz... En el foro Hardware, firmware and software help |
hace 2 years | |
|
Yeah I could try that Anyway, a small print worked fine Bu... En el foro Hardware, firmware and software help |
hace 2 years | |
|
Doesnt extrude at certain position En el foro Hardware, firmware and software help |
hace 2 years |