Notifications
Clear all
Cramb7
Groupe: Enregistré
A(ont) rejoint: 2023/01/18
Active Member
1
|
stupid me found the problem. there was some filament stuck u... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
Yeah but why does this occur so suddenly? Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
So i looked at the axle while printing. It was always rotati... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
Not sure if I understand axle right. You mean the middle thi... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
So i moved the model and did also a first layer calibration.... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
Hmm. In fact, after I removed the blob around the jammed noz... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
Yeah I could try that Anyway, a small print worked fine Bu... Dans le forum Hardware, firmware and software help |
il y a 2 years | |
|
Doesnt extrude at certain position Dans le forum Hardware, firmware and software help |
il y a 2 years |