Prusa3D Forum

Notifications

Clear all

Cramb7

Skupina: Registrovaný

Přidal se: 2023/01/18

Active Member

	stupid me found the problem. there was some filament stuck u... In forum Hardware, firmware and software help	před 2 years
	Yeah but why does this occur so suddenly? In forum Hardware, firmware and software help	před 2 years
	So i looked at the axle while printing. It was always rotati... In forum Hardware, firmware and software help	před 2 years
	Not sure if I understand axle right. You mean the middle thi... In forum Hardware, firmware and software help	před 2 years
	So i moved the model and did also a first layer calibration.... In forum Hardware, firmware and software help	před 2 years
	Hmm. In fact, after I removed the blob around the jammed noz... In forum Hardware, firmware and software help	před 2 years
	Yeah I could try that Anyway, a small print worked fine Bu... In forum Hardware, firmware and software help	před 2 years
	Doesnt extrude at certain position In forum Hardware, firmware and software help	před 2 years

Fórum Statistiky

559 Fóra

62.6 K Témata

441.7 K Příspěvky

20 Online

67.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed