Avisos
Vaciar todo
CONEJO
Grupo: Registrado
Registrado: 2025/04/01
Active Member
1
|
ahhh thanks, since I was printing with only one filament, I ... En el foro PrusaSlicer |
hace 1 month | |
|
What is this ... ¿thing? recently chagne to MMU3 and it appe... En el foro PrusaSlicer |
hace 1 month | |
|
Ok, has been reading a little bit and my problem was "heat c... En el foro Assembly and first prints troubleshooting |
hace 7 months | |
|
You might be right...
Good prints happened yesterday night... En el foro Assembly and first prints troubleshooting |
hace 7 months | |
|
There isn't any hard corners/curves on the bowden tube. It d... En el foro Assembly and first prints troubleshooting |
hace 7 months | |
|
Extruder skipping steps after a while En el foro Assembly and first prints troubleshooting |
hace 7 months | |
| yes, same here. I was tempted to cancel and order an assembl... | hace 9 months | |
| I confirmed this with chat support yesterday, and posted abo... | hace 9 months | |
| I asked support, but couldn't fully understand why ordering ... | hace 10 months |