Notifications
Clear all
CONEJO
Skupina: Registrovaný
Přidal se: 2025/04/01
Active Member
1
| Ok, has been reading a little bit and my problem was "heat c... | před 6 months | |
| You might be right... Good prints happened yesterday night... | před 6 months | |
| There isn't any hard corners/curves on the bowden tube. It d... | před 6 months | |
| Extruder skipping steps after a while | před 6 months | |
| yes, same here. I was tempted to cancel and order an assembl... | před 8 months | |
| I confirmed this with chat support yesterday, and posted abo... | před 8 months | |
| I asked support, but couldn't fully understand why ordering ... | před 8 months |