Benachrichtigungen
Alles löschen
CONEJO
Gruppe: Registriert
Beigetreten: 2025/04/01
Active Member
1
|
ahhh thanks, since I was printing with only one filament, I ... Im Forum PrusaSlicer |
Vor 1 month | |
|
What is this ... ¿thing? recently chagne to MMU3 and it appe... Im Forum PrusaSlicer |
Vor 1 month | |
| Ok, has been reading a little bit and my problem was "heat c... | Vor 7 months | |
| You might be right... Good prints happened yesterday night... | Vor 7 months | |
| There isn't any hard corners/curves on the bowden tube. It d... | Vor 7 months | |
| Extruder skipping steps after a while | Vor 7 months | |
| yes, same here. I was tempted to cancel and order an assembl... | Vor 9 months | |
| I confirmed this with chat support yesterday, and posted abo... | Vor 9 months | |
| I asked support, but couldn't fully understand why ordering ... | Vor 10 months |