Prusa3D Forum

Notifications

Clear all

CONEJO

Group: Registered

Joined: 2025/04/01

Active Member

	Ok, has been reading a little bit and my problem was "heat c... In forum Assembly and first prints troubleshooting	3 months ago
	You might be right... Good prints happened yesterday night... In forum Assembly and first prints troubleshooting	3 months ago
	There isn't any hard corners/curves on the bowden tube. It d... In forum Assembly and first prints troubleshooting	4 months ago
	Extruder skipping steps after a while In forum Assembly and first prints troubleshooting	4 months ago
	yes, same here. I was tempted to cancel and order an assembl... In forum General discussion, announcements and releases	6 months ago
	I confirmed this with chat support yesterday, and posted abo... In forum General discussion, announcements and releases	6 months ago
	I asked support, but couldn't fully understand why ordering ... In forum General discussion, announcements and releases	6 months ago

Forum Statistics

585 Forums

68.2 K Topics

477.7 K Posts

11 Online

75.9 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed