Prusa3D Forum

Notifications

Clear all

CONEJO

Grupa: Zarejestrowany

Dołączył: 2025/04/01

Active Member

	ahhh thanks, since I was printing with only one filament, I ... In forum PrusaSlicer	6 months temu
	What is this ... ¿thing? recently chagne to MMU3 and it appe... In forum PrusaSlicer	6 months temu
	Ok, has been reading a little bit and my problem was "heat c... In forum Assembly and first prints troubleshooting	1 year temu
	You might be right... Good prints happened yesterday night... In forum Assembly and first prints troubleshooting	1 year temu
	There isn't any hard corners/curves on the bowden tube. It d... In forum Assembly and first prints troubleshooting	1 year temu
	Extruder skipping steps after a while In forum Assembly and first prints troubleshooting	1 year temu
	yes, same here. I was tempted to cancel and order an assembl... In forum General discussion, announcements and releases	1 year temu
	I confirmed this with chat support yesterday, and posted abo... In forum General discussion, announcements and releases	1 year temu
	I asked support, but couldn't fully understand why ordering ... In forum General discussion, announcements and releases	1 year temu

Statystyki Forum

613 Fora

71.9 K Tematy

504.8 K Posty

12 Online

82.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte