Prusa3D Forum

Benachrichtigungen

Alles löschen

CONEJO

Gruppe: Registriert

Beigetreten: 2025/04/01

Active Member

	Ok, has been reading a little bit and my problem was "heat c... Im Forum Assembly and first prints troubleshooting	Vor 6 months
	You might be right... Good prints happened yesterday night... Im Forum Assembly and first prints troubleshooting	Vor 6 months
	There isn't any hard corners/curves on the bowden tube. It d... Im Forum Assembly and first prints troubleshooting	Vor 6 months
	Extruder skipping steps after a while Im Forum Assembly and first prints troubleshooting	Vor 6 months
	yes, same here. I was tempted to cancel and order an assembl... Im Forum General discussion, announcements and releases	Vor 8 months
	I confirmed this with chat support yesterday, and posted abo... Im Forum General discussion, announcements and releases	Vor 8 months
	I asked support, but couldn't fully understand why ordering ... Im Forum General discussion, announcements and releases	Vor 8 months

Forums-Statistiken

595 Foren

69.1 K Themen

483.3 K Beiträge

15 Online

78.1 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen