Prusa3D Forum

Notifications

Clear all

colezajicek

Groupe: Enregistré

A(ont) rejoint: 2017/12/12

Active Member

	Ok, cool. I'm not too worried about physically assembling it... Dans le forum Hardware, firmware and software help	il y a 7 years
	So I checked out the upgrade, and read through your thread a... Dans le forum Hardware, firmware and software help	il y a 7 years
	Z-axis expansion Dans le forum Hardware, firmware and software help	il y a 7 years
	Second completely unplugging the filament sensor. It caused ... Dans le forum Others (Archive)	il y a 7 years
	Looks like a solid design to me. Where is everyone wiring t... Dans le forum Others (Archive)	il y a 7 years
	i figured it out, its a firmware issue! I was on the latest... Dans le forum Others (Archive)	il y a 7 years
	ABS curling and overhang failures Dans le forum Others (Archive)	il y a 7 years
	Spent a couple hour chatting with support yesterday while di... Dans le forum Others (Archive)	il y a 7 years
	Cold pull came out as perfect as it gets, so it's not a bloc... Dans le forum Others (Archive)	il y a 7 years
	I also just read this post: My clicking stated before I mo... Dans le forum Others (Archive)	il y a 7 years
	I'm not sure about the rust, I also noticed it mentioned in ... Dans le forum Others (Archive)	il y a 7 years
	With the extruder cleaned up. Not sure if the deformed lower... Dans le forum Others (Archive)	il y a 7 years
	This is the initial view of what my filament is doing on the... Dans le forum Others (Archive)	il y a 7 years
	I'm having the same issue, I've tried printing at different ... Dans le forum Others (Archive)	il y a 7 years

Statistiques du forum

565 Forums

64.1 K Sujets

449.1 K Messages

17 En-ligne

70.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé