Prusa3D Forum

Benachrichtigungen

Alles löschen

colezajicek

Gruppe: Registriert

Beigetreten: 2017/12/12

Active Member

	Ok, cool. I'm not too worried about physically assembling it... Im Forum Hardware, firmware and software help	Vor 7 years
	So I checked out the upgrade, and read through your thread a... Im Forum Hardware, firmware and software help	Vor 7 years
	Z-axis expansion Im Forum Hardware, firmware and software help	Vor 7 years
	Second completely unplugging the filament sensor. It caused ... Im Forum Others (Archive)	Vor 7 years
	Looks like a solid design to me. Where is everyone wiring t... Im Forum Others (Archive)	Vor 7 years
	i figured it out, its a firmware issue! I was on the latest... Im Forum Others (Archive)	Vor 7 years
	ABS curling and overhang failures Im Forum Others (Archive)	Vor 7 years
	Spent a couple hour chatting with support yesterday while di... Im Forum Others (Archive)	Vor 7 years
	Cold pull came out as perfect as it gets, so it's not a bloc... Im Forum Others (Archive)	Vor 7 years
	I also just read this post: My clicking stated before I mo... Im Forum Others (Archive)	Vor 7 years
	I'm not sure about the rust, I also noticed it mentioned in ... Im Forum Others (Archive)	Vor 7 years
	With the extruder cleaned up. Not sure if the deformed lower... Im Forum Others (Archive)	Vor 7 years
	This is the initial view of what my filament is doing on the... Im Forum Others (Archive)	Vor 7 years
	I'm having the same issue, I've tried printing at different ... Im Forum Others (Archive)	Vor 7 years

Forums-Statistiken

585 Foren

68 K Themen

476.8 K Beiträge

11 Online

75.7 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen