Prusa3D Forum

Avisos

Vaciar todo

colezajicek

Grupo: Registrado

Registrado: 2017/12/12

Active Member

	Ok, cool. I'm not too worried about physically assembling it... En el foro Hardware, firmware and software help	hace 7 years
	So I checked out the upgrade, and read through your thread a... En el foro Hardware, firmware and software help	hace 7 years
	Z-axis expansion En el foro Hardware, firmware and software help	hace 7 years
	Second completely unplugging the filament sensor. It caused ... En el foro Others (Archive)	hace 7 years
	Looks like a solid design to me. Where is everyone wiring t... En el foro Others (Archive)	hace 7 years
	i figured it out, its a firmware issue! I was on the latest... En el foro Others (Archive)	hace 7 years
	ABS curling and overhang failures En el foro Others (Archive)	hace 7 years
	Spent a couple hour chatting with support yesterday while di... En el foro Others (Archive)	hace 7 years
	Cold pull came out as perfect as it gets, so it's not a bloc... En el foro Others (Archive)	hace 7 years
	I also just read this post: My clicking stated before I mo... En el foro Others (Archive)	hace 7 years
	I'm not sure about the rust, I also noticed it mentioned in ... En el foro Others (Archive)	hace 7 years
	With the extruder cleaned up. Not sure if the deformed lower... En el foro Others (Archive)	hace 7 years
	This is the initial view of what my filament is doing on the... En el foro Others (Archive)	hace 7 years
	I'm having the same issue, I've tried printing at different ... En el foro Others (Archive)	hace 7 years

Estadísticas del Foro

565 Foros

64.1 K Temas

449.1 K Respuestas

19 En línea

70.2 K Miembros

Iconos del foro: El foro no contiene publicaciones sin leer El foro contiene publicaciones sin leer

Iconos de los Temas: No respondidos Respondido Activo Popular Fijo No aprobados Resuelto Privado Cerrado