Notifications
Clear all
Cashew92ftw
Cashew92ftw
Skupina: Registrovaný
Přidal se: 2021/01/13
Trusted Member
3
Would a factory reset clear the statistics? And/or need any ...

In forum General discussion, announcements and releases

před 4 months
Print job picture question?

In forum Introduction & Instructions

před 4 months
I too have this issue, and have had it for some time now. ...

In forum General discussion, announcements and releases

před 4 months
Well i pulled the trigger on canceling my order. This was du...

In forum General discussion, announcements and releases

před 1 year
Im prettymuch in the same boat.

In forum General discussion, announcements and releases

před 1 year
What is the purpouse for the Coax plug on the buddy board?

In forum Hardware, firmware and software help

před 2 years
Wouldnt that mean i would have heat creep when i switch back...

In forum Hardware, firmware and software help

před 3 years
I did double check for the 0.4 nozzle, both on the slicer an...

In forum Hardware, firmware and software help

před 3 years
Nozzle X Underextruding

In forum Hardware, firmware and software help

před 3 years
Thanks for the heads up.

In forum General discussion, announcements and releases

před 3 years
Im going to guess july.

In forum General discussion, announcements and releases

před 3 years
Looking forward to see what other addons will be available ...

In forum General discussion, announcements and releases

před 3 years
I was looking forward to the idea of a mk4. Prettymuch a mk3...

In forum General discussion, announcements and releases

před 3 years
@averageprintingjoe I see you may not be expiereced with the...

In forum General discussion, announcements and releases

před 4 years
@averageprintingjoe What are your thoughts on remote drive s...

In forum General discussion, announcements and releases

před 4 years
@neolker Did you ever do any rfid testing on the buddy board...

In forum Hardware, firmware and software help

před 4 years
@szkifi I measured about 175 cm for the printer to powerbric...

In forum General discussion, announcements and releases

před 4 years
@altarus I think its the bolt and nut, though tbh i think my...

In forum General discussion, announcements and releases

před 4 years
@oxygen I honstly havent bothered going back to the other 2 ...

In forum General discussion, announcements and releases

před 4 years
@oxygen Its got a nice feel on the first layer imo  1...

In forum General discussion, announcements and releases

před 4 years
Stránka 1 / 3
Share: