Prusa3D Forum

Notifications

Clear all

Camperinho

Grupa: Zarejestrowany

Dołączył: 2018/10/20

Active Member

	Ok, now this is a bit embarrassing, it turned out that I ord... In forum Hardware, firmware and software help	5 years temu
	You guys are right, thanks. I contacted my reseller, will se... In forum Hardware, firmware and software help	5 years temu
	A factory reset with all data wiped didn't change anything a... In forum Hardware, firmware and software help	5 years temu
	Alright, I probably can do again a data clear this evening. ... In forum Hardware, firmware and software help	5 years temu
	this is the one: So I guess, it's a genuine. @David-a66: I ... In forum Hardware, firmware and software help	5 years temu
	PID Calibration doesn't work In forum Hardware, firmware and software help	5 years temu
	Yes, but I tried slowing down the print and double checked a... In forum Hardware, firmware and software help	6 years temu
	Mine, MK3 is doing layer shifts as well and I double checke... In forum Hardware, firmware and software help	6 years temu

Statystyki Forum

565 Fora

63.6 K Tematy

446.2 K Posty

22 Online

69 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte