Prusa3D Forum

Notifiche

Cancella tutti

Camperinho

Gruppo: Registrato

Registrato: 2018/10/20

Active Member

	Ok, now this is a bit embarrassing, it turned out that I ord... Nel forum Hardware, firmware and software help	6 years fa
	You guys are right, thanks. I contacted my reseller, will se... Nel forum Hardware, firmware and software help	6 years fa
	A factory reset with all data wiped didn't change anything a... Nel forum Hardware, firmware and software help	6 years fa
	Alright, I probably can do again a data clear this evening. ... Nel forum Hardware, firmware and software help	6 years fa
	this is the one: So I guess, it's a genuine. @David-a66: I ... Nel forum Hardware, firmware and software help	6 years fa
	PID Calibration doesn't work Nel forum Hardware, firmware and software help	6 years fa
	Yes, but I tried slowing down the print and double checked a... Nel forum Hardware, firmware and software help	7 years fa
	Mine, MK3 is doing layer shifts as well and I double checke... Nel forum Hardware, firmware and software help	7 years fa

Statistiche Forum

585 Forum

68.2 K Discussioni

477.6 K Post

17 Online

75.9 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso