Prusa3D Forum

Notifications

Clear all

Camperinho

Skupina: Registrovaný

Přidal se: 2018/10/20

Active Member

	Ok, now this is a bit embarrassing, it turned out that I ord... In forum Hardware, firmware and software help	před 6 years
	You guys are right, thanks. I contacted my reseller, will se... In forum Hardware, firmware and software help	před 6 years
	A factory reset with all data wiped didn't change anything a... In forum Hardware, firmware and software help	před 6 years
	Alright, I probably can do again a data clear this evening. ... In forum Hardware, firmware and software help	před 6 years
	this is the one: So I guess, it's a genuine. @David-a66: I ... In forum Hardware, firmware and software help	před 6 years
	PID Calibration doesn't work In forum Hardware, firmware and software help	před 6 years
	Yes, but I tried slowing down the print and double checked a... In forum Hardware, firmware and software help	před 7 years
	Mine, MK3 is doing layer shifts as well and I double checke... In forum Hardware, firmware and software help	před 7 years

Fórum Statistiky

585 Fóra

68.2 K Témata

477.6 K Příspěvky

14 Online

75.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed