Polski
Fora
Członkowie
bacterio
Aktywność
 
Notifications
Clear all
bacterio
bacterio
Grupa: Zarejestrowany
Dołączył: 2016/06/21
Active Member
1
Profil Aktywność
BTW, the setting are in a separate github repo. Ugh! My bad...

In forum Software (Archive)

 9 years temu
Josef is answering questions about the upgrade in this reddi...

In forum Others (Archive)

 9 years temu
Actually we provide a Slic3r build for 64bit linux, built on...

In forum Software (Archive)

 9 years temu
Check this thread, lots of info and suggestions about the pr...

In forum Others (Archive)

 9 years temu
Well, I dit. Much faster and easier than I was expecting. Th...

In forum Software (Archive)

 9 years temu
I have also noticed the front 3 points on the bed are lower ...

In forum Prusa i3 kit (Archive)

 9 years temu
Hooray! Sadly I'm stuck with RH/CentOS/Fedora flavours for ...

In forum Software (Archive)

 9 years temu
suggestions of specific tools, etc welcom I'm using these t...

In forum Others (Archive)

 9 years temu
Hi, finally I made the second version. Love the new desig...

In forum Improvements (Archive)

 9 years temu
Any Ideas ? Uhm... not really. I move to Red Hat/Fedora lon...

In forum Software (Archive)

 9 years temu
I unload filament at 170°C and only then (before loading new...

In forum Others (Archive)

 10 years temu
Since there are not Linux builds from Prusa, I'm using the S...

In forum Software (Archive)

 10 years temu
Wow! Lots of ideas to steal for my own enclosure. I like a ...

In forum Improvements (Archive)

 10 years temu
Turns out that the bench cookies are not a good idea. The ru...

In forum Improvements (Archive)

 10 years temu
If you press the knob the backlit goes off and the speaker b...

In forum Others (Archive)

 10 years temu
Hello (first post here). I have my printer sitting of top o...

In forum Improvements (Archive)

 10 years temu
Share: