Italiano
Forum
Utenti
bacterio
Attività
 
Notifiche
Cancella tutti
bacterio
bacterio
Gruppo: Registrato
Registrato: 2016/06/21
Active Member
1
Profilo Attività
BTW, the setting are in a separate github repo. Ugh! My bad...

Nel forum Software (Archive)

 9 years fa
Josef is answering questions about the upgrade in this reddi...

Nel forum Others (Archive)

 9 years fa
Actually we provide a Slic3r build for 64bit linux, built on...

Nel forum Software (Archive)

 10 years fa
Check this thread, lots of info and suggestions about the pr...

Nel forum Others (Archive)

 10 years fa
Well, I dit. Much faster and easier than I was expecting. Th...

Nel forum Software (Archive)

 10 years fa
I have also noticed the front 3 points on the bed are lower ...

Nel forum Prusa i3 kit (Archive)

 10 years fa
Hooray! Sadly I'm stuck with RH/CentOS/Fedora flavours for ...

Nel forum Software (Archive)

 10 years fa
suggestions of specific tools, etc welcom I'm using these t...

Nel forum Others (Archive)

 10 years fa
Hi, finally I made the second version. Love the new desig...

Nel forum Improvements (Archive)

 10 years fa
Any Ideas ? Uhm... not really. I move to Red Hat/Fedora lon...

Nel forum Software (Archive)

 10 years fa
I unload filament at 170°C and only then (before loading new...

Nel forum Others (Archive)

 10 years fa
Since there are not Linux builds from Prusa, I'm using the S...

Nel forum Software (Archive)

 10 years fa
Wow! Lots of ideas to steal for my own enclosure. I like a ...

Nel forum Improvements (Archive)

 10 years fa
Turns out that the bench cookies are not a good idea. The ru...

Nel forum Improvements (Archive)

 10 years fa
If you press the knob the backlit goes off and the speaker b...

Nel forum Others (Archive)

 10 years fa
Hello (first post here). I have my printer sitting of top o...

Nel forum Improvements (Archive)

 10 years fa
Condividi: