Čeština
Fóra
Uživatelé
bacterio
Aktivita
 
Notifications
Clear all
bacterio
bacterio
Skupina: Registrovaný
Přidal se: 2016/06/21
Active Member
1
Profile Aktivita
BTW, the setting are in a separate github repo. Ugh! My bad...

In forum Software (Archive)

 před 9 years
Josef is answering questions about the upgrade in this reddi...

In forum Others (Archive)

 před 9 years
Actually we provide a Slic3r build for 64bit linux, built on...

In forum Software (Archive)

 před 9 years
Check this thread, lots of info and suggestions about the pr...

In forum Others (Archive)

 před 9 years
Well, I dit. Much faster and easier than I was expecting. Th...

In forum Software (Archive)

 před 9 years
I have also noticed the front 3 points on the bed are lower ...

In forum Prusa i3 kit (Archive)

 před 9 years
Hooray! Sadly I'm stuck with RH/CentOS/Fedora flavours for ...

In forum Software (Archive)

 před 9 years
suggestions of specific tools, etc welcom I'm using these t...

In forum Others (Archive)

 před 9 years
Hi, finally I made the second version. Love the new desig...

In forum Improvements (Archive)

 před 9 years
Any Ideas ? Uhm... not really. I move to Red Hat/Fedora lon...

In forum Software (Archive)

 před 10 years
I unload filament at 170°C and only then (before loading new...

In forum Others (Archive)

 před 10 years
Since there are not Linux builds from Prusa, I'm using the S...

In forum Software (Archive)

 před 10 years
Wow! Lots of ideas to steal for my own enclosure. I like a ...

In forum Improvements (Archive)

 před 10 years
Turns out that the bench cookies are not a good idea. The ru...

In forum Improvements (Archive)

 před 10 years
If you press the knob the backlit goes off and the speaker b...

In forum Others (Archive)

 před 10 years
Hello (first post here). I have my printer sitting of top o...

In forum Improvements (Archive)

 před 10 years
Share: