Prusa3D Forum

Notifications

Clear all

bacterio

Groupe: Enregistré

A(ont) rejoint: 2016/06/21

Active Member

	BTW, the setting are in a separate github repo. Ugh! My bad... Dans le forum Software (Archive)	il y a 8 years
	Josef is answering questions about the upgrade in this reddi... Dans le forum Others (Archive)	il y a 8 years
	Actually we provide a Slic3r build for 64bit linux, built on... Dans le forum Software (Archive)	il y a 8 years
	Check this thread, lots of info and suggestions about the pr... Dans le forum Others (Archive)	il y a 8 years
	Well, I dit. Much faster and easier than I was expecting. Th... Dans le forum Software (Archive)	il y a 8 years
	I have also noticed the front 3 points on the bed are lower ... Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	Hooray! Sadly I'm stuck with RH/CentOS/Fedora flavours for ... Dans le forum Software (Archive)	il y a 8 years
	suggestions of specific tools, etc welcom I'm using these t... Dans le forum Others (Archive)	il y a 8 years
	Hi, finally I made the second version. Love the new desig... Dans le forum Improvements (Archive)	il y a 8 years
	Any Ideas ? Uhm... not really. I move to Red Hat/Fedora lon... Dans le forum Software (Archive)	il y a 8 years
	I unload filament at 170°C and only then (before loading new... Dans le forum Others (Archive)	il y a 8 years
	Since there are not Linux builds from Prusa, I'm using the S... Dans le forum Software (Archive)	il y a 8 years
	Wow! Lots of ideas to steal for my own enclosure. I like a ... Dans le forum Improvements (Archive)	il y a 8 years
	Turns out that the bench cookies are not a good idea. The ru... Dans le forum Improvements (Archive)	il y a 8 years
	If you press the knob the backlit goes off and the speaker b... Dans le forum Others (Archive)	il y a 8 years
	Hello (first post here). I have my printer sitting of top o... Dans le forum Improvements (Archive)	il y a 8 years

Statistiques du forum

565 Forums

63.6 K Sujets

446 K Messages

22 En-ligne

68.9 K Membres

Le dernier des messages: Printing failure after installing 0.6 nozzle Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé