Prusa3D Forum

Notifications

Clear all

Azonic3D

Groupe: Enregistré

A(ont) rejoint: 2025/07/23

Active Member

	I did just run accross this site; no Prusament colors came u... Dans le forum General discussion, announcements and releases	il y a 3 weeks
	Best filament color match? Red? Dans le forum General discussion, announcements and releases	il y a 3 weeks
	I had no idea that setting existed; I will try that. Thanks! Dans le forum How do I print this? (Printing help)	il y a 2 months
	I had a similar thing happen when I was printing PETG-CF. A ... Dans le forum How do I print this? (Printing help)	il y a 2 months
	Tips for layer "gaps" on PETG? Dans le forum How do I print this? (Printing help)	il y a 2 months
	Tips for printing "organic" shapes with supports? Dans le forum How do I print this? (Printing help)	il y a 2 months
	Not yet, but will try in the next run! Dans le forum How do I print this? (Printing help)	il y a 3 months
	Thanks for this @raax-2 ! Really like the results I got out ... Dans le forum How do I print this? (Printing help)	il y a 3 months
	Ok, this is good feedback. I can't seem to get it lower with... Dans le forum How do I print this? (Printing help)	il y a 3 months
	It is. I agree it could be optimized for additive. Appreciat... Dans le forum How do I print this? (Printing help)	il y a 3 months
	Ok, here were the settings I changed: Set the machine on Ste... Dans le forum How do I print this? (Printing help)	il y a 3 months
	I don't seem to see those settings for filament. Perhaps cha... Dans le forum How do I print this? (Printing help)	il y a 3 months
	Perfect, I'll try these tweaks and report back. Thank you! Dans le forum How do I print this? (Printing help)	il y a 3 months
	Maybe it has to be a .zip file? I attached the .3MF file. Wi... Dans le forum How do I print this? (Printing help)	il y a 3 months
	Not sure the attachment is coming through Dans le forum How do I print this? (Printing help)	il y a 3 months
	Let's see if this works. Thanks! Dans le forum How do I print this? (Printing help)	il y a 3 months
	Thanks for the feedback! Since the design is proprietary, is... Dans le forum How do I print this? (Printing help)	il y a 3 months
	Glitch in the Matrix? (How did this happen?) Dans le forum How do I print this? (Printing help)	il y a 3 months

Page 1 / 2 Suivant

Statistiques du forum

585 Forums

68.3 K Sujets

478.1 K Messages

10 En-ligne

76.1 K Membres

Le dernier des messages: What filament dryer to use? Notre nouveau membre: ArtiVIVO Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé