Notifications
Clear all
arosso
arosso
Skupina: Registrovaný
Přidal se: 2018/10/21
Eminent Member
2
I spent about 2 months getting this right on my MK3. Same is...

In forum Assembly and first prints troubleshooting

před 6 years
Finally had some success. I think the following made the dif...

In forum How do I print this? (Printing help)

před 6 years
The comments on the MVS made me go research this a bit more....

In forum How do I print this? (Printing help)

před 6 years
1. For my MVS I've set this to 5 mm^3/s. I had started at 9 ...

In forum How do I print this? (Printing help)

před 6 years
I only tried 225C without Fan and that clogged too. I didn't...

In forum How do I print this? (Printing help)

před 6 years
I decided to push the temperature to 250C and switch off the...

In forum How do I print this? (Printing help)

před 6 years
Understanding Clogging - Carbon Fiber PLA

In forum How do I print this? (Printing help)

před 6 years
I saw this too on my MK3S upgrade. They are just trying to d...

In forum Assembly and first prints troubleshooting

před 6 years
Hmm... if the first layer seems even then I'm not sure. A fe...

In forum How do I print this? (Printing help)

před 6 years
How does the first layer of the print look? I would try to s...

In forum How do I print this? (Printing help)

před 6 years
Yes, I've been keeping an eye on this a bit closer the last ...

In forum How do I print this? (Printing help)

před 6 years
I can't say I've experienced the magical adhesion properties...

In forum How do I print this? (Printing help)

před 6 years
PEI Cleaning and Temperature

In forum How do I print this? (Printing help)

před 6 years
My multi model print didn't go so well. The 'lip curl' I was...

In forum How do I print this? (Printing help)

před 6 years
I would assume that since the curling is due to heat just pa...

In forum How do I print this? (Printing help)

před 6 years
Thanks for the pointers. Yes, I've tried slowing things do...

In forum How do I print this? (Printing help)

před 6 years
Is this a retraction problem or something else?

In forum How do I print this? (Printing help)

před 6 years
The IPA I use is this one: . I'm not sure if they are requir...

In forum How do I print this? (Printing help)

před 6 years
I've been using those blue Scotts Shop paper towels: Maybe...

In forum How do I print this? (Printing help)

před 6 years
I clean the sheet with Isopropyl alcohol (91%) each time. I'...

In forum How do I print this? (Printing help)

před 6 years
Stránka 1 / 2
Share: